FCP50A Single-turn Potentiometer

1-turn Potentiometer | Conductive plastic (Servomount)

About the FCP50A Single-turn Potentiometer

The FCP50A is a servomount type potentiometer with ball bearings, a 51mm outer diameter and turret side terminals.

Features FCP50A - Conductive plastic (Servomount)

  • Conductive plastic
  • Dimensions D x L (mm): 50.8 x 18
  • Standard Resistance Range 1 to 10 kilo ohm
  • Independent Linearity (± %): 0.5 to 0.05
  • Mechanical travel (+10° 0°): 360°
  • Electrical travel (±5°): 350° ±5°

Special Specifications Available

Extra taps (available up to 3 taps), multi-ganged (available up to 7 gangs, housing length is extended by 12mm per 1 gang), shaft with front and rear extension (rear shaft with 6mm dia. and 15mm length), with stopper (rotating angle becomes 320º and stopper strength is 0.9N·m [9kgf·cm]), special electrical travel, shaft dia. (ø6.35mm) with inch dimensions, special machining on the shaft.

Specifications

Shaft diameter (mm)
6
Standard Resistance Values
1k, 2k, 5k, 10 k (O)
Special Practical resistance Values
500, 20k, 50k, 100k, 200k, 500k (O)
Total resistance tolerance
Standard Class ±10% (K)
Independent linearity tolerance
Standard Class ±0.5%, Precision Class ±0.2%, Super precision Class ±0.05%
Resolution
Essentially infinit
Output Smoothness
Within 0.1% against input voltage
Contact Resistance Variation
Within 2% C.R.V.
Power Rating
3.0W
Electrical Travel
350º ±5º
Mechanical Travel
360º (Endless)
Insulation Resistance
Over 1,000MO at 1,000 V.D.C
Dielectric Strength
1 minute at 1,000 V.A.C.
Starting Torque
Within 4mN·m (40gf·cm)
Resistance temp. coefficient
±400p.p.m./ºC
Mass
Approx. 80g
  • Follow us: