FCPS22AC Single-turn Potentiometer
Servomount - Oilless Metal Bearings Incorporated
Eigenschaften
- Conductive plastic
- Dimensions D x L (mm): 22x20
- Standard Resistance Range 1 Ω to 10 kΩ
- Independent Linearity (± %): 1 to 0.5
- Mechanical travel (+10° 0°): 360°
- Electrical travel (±5°): 320° ±5°
About the FCPS22AC Single-turn Potentiometer - Conductive plastic (Servomount oilless metal bearings incorporated)
The FCPS22AC is a low-cost servomount type potentiometer with oil-less metal bearing and rear extended turret terminals.
Special Specifications Available
Extra taps (available up to 1 tap), shaft with front and rear extension (rear shaft with 3mm dia. and 20mm length), with stopper (rotating angle becomes 320º and stopper strength is 0.9N·m [9kgf·cm]), special electrical travel, shaft dia. (ø6.35mm), special machining on the shaft, with ball bearings incorporated.
Benötigen Sie diesen Sensor für Ihr nächstes Projekt?
Fordern Sie jetzt ein Angebot an oder lassen Sie sich kostenfrei von unseren Experten beraten!
Produkt Downloads
Maßgeschneidert nach Ihren Anforderungen
Nicht das richtige Produkt? Wir bieten Ihnen sowohl Standard Sensoren als auch maßgeschneiderte Produkte und komplette Messlösungen. Bitte kontaktieren Sie uns für eine Beratung oder ein unverbindliches Angebot!
KontaktTechnische Spezifikationen
Spezifikationen | Wert |
---|---|
360º (endless) | Over 1,000MΩ at 500 V.D.C |
Contact resistance variation | Within 2% C.R.V. |
Dielectric strength | 1 minute at 500 V.A.C. |
Electrical travel | 320º ±5º |
Independent linearity tolerance | Standard Class ±1.0%, Precision Class ±0.5% |
Mass | Approx. 30g |
Mechanical travel | 360º (Endless) |
Output smoothness | Within 0.1% against input voltage |
Power rating | 1.0W |
Resistance temp. coefficient | ±400p.p.m./ºC |
Resolution | Essentially infinite |
Shaft diameter (mm) | 6 |
Special practical resistance values | 500, 20k, 50k, 100k (Ω) |
Standard resistance values | 1k, 2k, 5k, 10 k (Ω) |
Starting torque | Within 5mN·m (50gf·cm) |
Total resistance tolerance | Standard Class ±15% (L), Precision Class ±10% (K) |