FCP40A Single-turn Potentiometer

1-turn Potentiometer - Geleidend plastic (Servomount)

Features FCP40A 

  • Conductive plastic
  • Dimensions D x L (mm): 36.5x18
  • Standard Resistance Range 1 Ω to 10 kΩ
  • Independent Linearity (± %): 0.5 to 0.1
  • Mechanical travel (+10° 0°): 360°
  • Electrical travel (±5°): 340° ±5°


Neem contact op voor een prijsaanvraag, een offerte of advies.

About the FCP40A Single-turn Potentiometer- Conductive plastic (Servomount)

The FCP40A is a servomount type potentiometer with ball bearings, a 37mm outer diameter and turret side terminals.

Special Specifications Available

Extra taps (available up to 3 taps), multi-ganged (available up to 7 gangs, housing length is extended by 12mm per 1 gang), shaft with front and rear extension (rear shaft with 6mm dia. and 15mm length), with stopper (rotating angle becomes 320º and stopper strength is 0.9N·m [9kgf·cm]), special electrical travel, shaft dia. (ø6.35mm) with inch dimensions, special machining on the shaft.

  • Specificaties
  • Datasheet(s)
Shaft diameter (mm)
Standard Resistance Values
1k, 2k, 5k, 10 k (Ω)
Special Practical resistance Values
500, 20k, 50k, 100k, 200k (Ω)
Total resistance tolerance
Standard Class ±10% (K)
Independent linearity tolerance
Standard Class ±0.5%, Precision Class ±0.25%, Super precision Class ±0.1%
Essentially infinite
Output Smoothness
Within 0.1% against input voltage
Contact Resistance Variation
Within 2% C.R.V.
Power Rating
Electrical Travel
340º ±5º
Mechanical Travel
360º (Endless)
Insulation Resistance
Over 1,000MΩ at 1,000 V.D.C
Dielectric Strength
1 minute at 1,000 V.A.C.
Starting Torque
Within 3mN·m (30gf·cm)
Resistance temp. coefficient
Approx. 60g


Neem contact op voor een prijsaanvraag, een offerte of advies.

Deel deze pagina:
  • Volg ons: